9/17/2023 0 Comments Thermacam Researcher Serial Number![]() TEC Automation was able to provide the manufacturer with a comprehensive control and data acquisition system, as well as part imaging and measurement specific to each drum instead of one-size-fits-all spot measurements as in the past. The spinning shell forms the molten iron in a homogenous layer that bonds to the steel shell and can then be machined to a specific thickness to create the final brake drum.Ī global manufacturer of braking systems for heavy equipment recently contracted TEC Automation to replace several older laser pyrometers with an IR camera system to monitor casting process parameters. Molten iron at approximately 2700☏ is then poured into the shell as it spins at high speeds. ![]() The shell is placed into a centrifugal casting machine and heated to a bonding temperature of approximately 1800☏. Each drum is formed by heating a steel shell that is made by bending steel strips of varying widths-depending on brake type and vehicle-into a circle. Most heavy equipment uses drum brakes rather than disc brakes. An infrared (IR) system has been developed by system integrator TEC Automation to perform this function during the brake drum casting process. ![]() Braking systems for such equipment are critical and each component must be tracked for product liability or potential recall. Infrared imaging inspects braking drums for centrifugal casting defects during productionįor heavy equipment such as tractors and bulldozers, the ability to stop momentum is more important than acceleration. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |